Alternator: Testing and Inspection

2ZR-FE CHARGING: GENERATOR: INSPECTION

1. INSPECT GENERATOR CLUTCH PULLEY

(a) Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.





(b) If the result is not as specified, replace the clutch pulley.

2. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

(a) Using vernier calipers, measure the length of the exposed brushes.





Standard exposed length:

9.5 to 11.5 mm (0.374 to 0.453 in.)

Minimum exposed length:

4.5 mm (0.177 in.)

(b) If the exposed length is less than the minimum, replace the brush holder assembly.

3. INSPECT GENERATOR ROTOR ASSEMBLY

(a) Check the generator rotor for an open circuit.





(1) Measure the resistance according to the value (s) in the table below.

Standard resistance:





(1) If the result is not as specified, replace the generator rotor assembly.

(b) Check the rotor for ground.





(1) Measure the resistance according to the value (s) in the table below.

Standard resistance:





(1) If the result is not as specified, replace the generator rotor assembly.

(c) Check that the generator rotor bearing is not rough or worn.





(d) If necessary, replace the generator rotor assembly.

(e) Using vernier calipers, measure the slip ring diameter.





Standard diameter:

14.2 to 14.4 mm (0.559 to 0.567 in.)

Minimum diameter:

14.0 mm (0.551 in.)

(f) If the diameter is less than the minimum, replace the generator rotor assembly.

4. INSPECT GENERATOR DRIVE END FRAME BEARING

(a) Check that the bearing is not rough or worn.





(b) If necessary, replace the generator drive end frame bearing.