Installation

U341E AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the park/neutral position switch assembly onto the manual valve lever shaft.

(b) Provisionally install the 2 bolts.

Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(d) Provisionally install the control shaft lever.

(e) Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.

(f) Remove the control shaft lever.

(g) Align the groove with the neutral basic line.

(h) Hold the switch in this position and tighten the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(i) Using a screwdriver, stake the nut with the lock plate.

(j) Install the control shaft lever with the nut and washer.

Torque : 13 Nm (129 kgf-cm, 9 ft-lbf)

(k) Connect the connector to the park/neutral position switch assembly.

2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Install the transmission control cable assembly onto the control shaft lever with the nut.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(b) Fix the transmission control cable assembly onto the control cable bracket with a new clip.

NOTICE:
Make sure that the marking on the cable is aligned with the slit in the transmission control cable bracket before installing the cable.

3. INSPECT SHIFT LEVER POSITION On-Vehicle Inspection

4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY On-Vehicle Inspection

5. INSTALL ENGINE UNDER COVER LH

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)