Installation

2ZR-FE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL TIMING CHAIN OR BELT COVER OIL SEAL





(a) Apply MP grease to a new oil seal lip.

(b) Using SST and a hammer, tap the oil seal until its surface is flush with the timing chain cover edge.

SST : 09223-22010

NOTICE:
* Do not tap the oil seal at an angle.
* Keep the lip free of foreign matter.
HINT
The pressing-in depth should be within the range of -1 mm and 1 mm from the chain cover edge.

2. INSTALL CRANKSHAFT PULLEY

(a) Align the pulley set key with the key groove of the pulley.

(b) Using SST, hold the pulley in place and tighten the bolt.





SST : 09213-58013

91651-60855

SST : 09330-00021

Torque : 190 Nm (1940 kgf-cm, 140 ft-lbf)

3. INSTALL FAN AND GENERATOR V BELT Installation

4. ADJUST FAN AND GENERATOR V BELT Installation

5. INSPECT FAN AND GENERATOR V BELT Installation

6. INSTALL NO. 2 CYLINDER HEAD COVER Installation

7. INSPECT FOR ENGINE OIL LEAK

8. INSTALL ENGINE UNDER COVER RH