Removal

2ZR-FE INTAKE: INTAKE MANIFOLD: REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE

Precaution

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE ENGINE UNDER COVER LH

4. REMOVE ENGINE UNDER COVER RH

5. DRAIN ENGINE COOLANT Service and Repair

6. REMOVE NO. 2 CYLINDER HEAD COVER Removal

7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE Removal

8. SEPARATE ENGINE WIRE HARNESS Removal

9. REMOVE HARNESS BRACKET Removal

10. DISCONNECT NO. 1 FUEL VAPOR FEED HOSE Removal

11. DISCONNECT VACUUM HOSE Removal

12. REMOVE FUEL PIPE CLAMP Removal

13. DISCONNECT FUEL TUBE SUB-ASSEMBLY Removal

14. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY Removal

15. REMOVE NO. 1 DELIVERY PIPE SPACER Removal

16. REMOVE INJECTOR VIBRATION INSULATOR Removal

17. REMOVE FLYWHEEL HOUSING SIDE COVER Removal

18. REMOVE STARTER ASSEMBLY Removal

19. REMOVE OIL COOLER TUBE

(a) Using a union nut wrench, separate the inlet No. 1 oil cooler tube while holding the oil cooler tube union with a wrench.

(b) Using a union nut wrench, separate the outlet No. 1 oil cooler tube while holding the oil cooler tube union with a wrench.

20. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY

(a) Remove the transmission oil level dipstick.

(b) Disconnect the breather hose.

(c) Remove the bolt and remove the transmission oil level gauge sub-assembly.

21. REMOVE ENGINE OIL LEVEL DIPSTICK

22. REMOVE THROTTLE BODY ASSEMBLY Removal

23. REMOVE INTAKE MANIFOLD

(a) Disconnect the 4 wire harness clamps.

(b) Disconnect the ventilation hose.