Installation

SUSPENSION: REAR COIL SPRING: INSTALLATION

1. INSTALL REAR COIL SPRING UPPER INSULATOR

(a) Install the rear coil spring upper insulator onto the rear coil spring.





NOTICE:
Install the rear coil spring upper insulator so that the dimension between the stopper and the upper end of the rear coil spring is 10 mm (0.39 in.) or less.

2. INSTALL REAR COIL SPRING LOWER INSULATOR

3. INSTALL REAR COIL SPRING

(a) Install the rear coil spring onto the rear axle beam.





NOTICE:
Install the rear coil spring so that the identification mark is positioned as shown in the illustration.

4. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH Installation

5. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH

HINT
Perform the same procedure as for the LH side.

6. CONNECT SKID CONTROL SENSOR WIRE (for LH Side) Installation

7. CONNECT SKID CONTROL SENSOR WIRE (for RH Side)

HINT
Perform the same procedure as for the LH side.

8. INSTALL REAR WHEELS

9. INSTALL REAR FLOOR SIDE MEMBER BRACE SUB-ASSEMBLY Installation

10. INSTALL REAR FLOOR SIDE MEMBER COVER RH Installation

11. INSTALL REAR FLOOR SIDE MEMBER COVER LH Installation

12. STABILIZE SUSPENSION Installation

13. FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY Installation

14. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH Installation

15. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH

HINT
Perform the same procedure as for the LH side.

16. INSPECT REAR WHEEL ALIGNMENT

Rear Wheel Alignment

17. CHECK VSC SENSOR SIGNAL

HINT
Test Mode Procedure