Reading and Clearing Diagnostic Trouble Codes

POWER STEERING: POWER STEERING SYSTEM: DTC CHECK / CLEAR

1. CHECK DTC

(a) Turn the ignition switch to OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / EMPS / Trouble Codes /

(f) Read the DTCs by following the prompts on the Techstream.

HINT
Refer to the Techstream operator's manual for further details.

2. CLEAR DTC

(a) Turn the ignition switch to OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / EMPS / Trouble Codes /

(f) Clear the DTCs by following the prompts on the Techstream.

(g) Turn the ignition switch to OFF.

(h) Disconnect the Techstream from the DLC3.