Installation

AXLE: STEERING KNUCKLE: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
1. INSTALL STEERING KNUCKLE

(a) Install the front disc brake dust cover onto the steering knuckle.

(b) Install the axle hub with the 4 bolts.





Torque : 96 Nm (979 kgf-cm, 71 ft-lbf)

NOTICE:
Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.

2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY Installation

3. INSTALL FRONT AXLE ASSEMBLY Installation

4. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY Installation

5. INSTALL FRONT DISC Installation

6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation

7. INSTALL TIE ROD END SUB-ASSEMBLY Installation

8. INSTALL FRONT AXLE HUB NUT Installation

9. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Removal

10. REMOVE FRONT DISC Removal

11. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub

12. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub

13. INSTALL FRONT DISC Installation

14. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation

15. INSTALL FRONT SPEED SENSOR Installation

16. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

17. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment Front Wheel Alignment.

18. CHECK VSC SENSOR SIGNAL

Check For Intermittent Problems