FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Installation





U241E AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the park/neutral position switch assembly onto the manual valve lever shaft.





(b) Provisionally install the 2 bolts.

(c) Replace the lock plate with a new one and tighten the manual valve shaft nut.





Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(d) Provisionally install the control shaft lever.





(e) Turn the control shaft lever counterclockwise until it stops, then turn it clockwise 2 notches.

(f) Remove the control shaft lever.

(g) Align the groove with the neutral basic line.





(h) Hold the switch in this position and tighten the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(i) Using a screwdriver, stake the nut with the lock plate.





(j) Install the control shaft lever with the nut.





Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)

(k) Install the transmission control cable assembly into the control shaft lever with the nut.





Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(l) Connect the connector to the park/neutral position switch assembly.





2. INSTALL NO. 2 BATTERY CARRIER Installation

3. INSTALL BATTERY Installation

4. INSPECT SHIFT LEVER POSITION On-Vehicle Inspection

5. ADJUST SHIFT LEVER POSITION Installation

6. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY On-Vehicle Inspection