Installation

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

HINT
The procedure described below is for the RH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.

1. INSTALL REAR AIRBAG SENSOR

(a) Confirm that the ignition switch is turned to OFF.

(b) Confirm that the negative battery terminal is detached.

CAUTION:
* Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
(c) Insert the hook into the body hole and install the airbag sensor with the bolt.

Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* Do not use a rear airbag sensor that has been dropped.
* Do not subject the rear airbag sensor to any impact or force.
(d) Confirm that there is no looseness by shaking the rear airbag sensor.





(e) Connect the airbag connector.





2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Installation

3. INSTALL REAR SEAT BACK HINGE SUB-ASSEMBLY

4. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH Installation

5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY Installation

6. INSTALL REAR DECK TRIM COVER Installation

7. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation

8. INSTALL REAR DOOR SCUFF PLATE RH Installation

9. INSTALL REAR SEATBACK ASSEMBLY RH Installation

10. INSTALL REAR SEATBACK ASSEMBLY LH Installation

11. INSTALL REAR SEAT CUSHION WITH COVER PAD SUB-ASSEMBLY Installation

12. INSTALL DECK FLOOR BOX RH Installation

13. INSTALL DECK FLOOR BOX LH Installation

14. INSTALL REAR DECK FLOOR BOX Installation

15. INSTALL REAR FLOOR CARPET ASSEMBLY Installation

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

17. INSPECT SRS WARNING LIGHT

Diagnosis System