Installation

2AZ-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION

1. INSTALL KNOCK SENSOR

(a) Install the knock sensor with the nut.

Torque : 20 Nm (205 kgf-cm, 15 ft-lbf)

(b) Connect the sensor connector.

2. INSTALL NO. 1 INTAKE MANIFOLD INSULATOR

(a) Install the No. 1 intake manifold insulator.

3. INSTALL INTAKE MANIFOLD

(a) Install a new gasket into the intake manifold.

(b) Install the intake manifold with the 5 bolts and 2 nuts.

Torque : 30 Nm (306 kgf-cm, 22 ft-lbf)

(e) Connect the ventilation hose.

4. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY WITH FUEL TUBE SUB-ASSEMBLY Installation

5. CONNECT FUEL TUBE SUB-ASSEMBLY Installation

6. INSTALL THROTTLE BODY ASSEMBLY Installation

7. INSTALL OUTER COWL TOP PANEL Installation

8. INSTALL FRONT WIPER MOTOR AND LINK Installation

9. INSTALL COWL TOP VENTILATOR LOUVER LH Installation

10. INSTALL COWL TOP VENTILATOR LOUVER RH Installation

11. INSTALL HOOD TO COWL TOP SEAL Installation

12. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation

13. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation

14. INSTALL WINDSHIELD WIPER ARM COVER Installation

15. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE Installation

16. ADD ENGINE COOLANT Service and Repair

17. INSPECT FOR COOLANT LEAK Testing and Inspection

18. INSPECT FOR FUEL LEAK

Fuel System Precautions

19. INSTALL NO. 1 ENGINE COVER Installation