Ignition Relay: Testing and Inspection

2AZ-FE ENGINE CONTROL SYSTEM: IGNITION RELAY NO. 1: ON-VEHICLE INSPECTION

1. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL SUB-ASSEMBLY Removal

2. REMOVE NO. 1 IGNITION RELAY





(a) Remove the No. 1 ignition relay.

3. INSPECT NO. 1 IGNITION RELAY

(a) Measure resistance of the No. 1 ignition relay.





Standard resistance:





If the result is not as specified, replace the relay.

4. INSTALL NO. 1 IGNITION RELAY

(a) Install the No. 1 ignition relay.

5. INSTALL INSTRUMENT PANEL FINISH LOWER PANEL SUB-ASSEMBLY Installation