Reassembly

BRAKE: BRAKE MASTER CYLINDER: REASSEMBLY

1. INSTALL MASTER CYLINDER RESERVOIR GROMMET

(a) Apply lithium soap base glycol grease to 2 new grommets.

(b) Install the 2 grommets onto the brake master cylinder reservoir.

2. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

(a) When installing a new brake master cylinder reservoir, cut out the clutch tube tip of the brake master cylinder reservoir as shown in the illustration (for Manual Transaxle).





NOTICE:
* Do not allow any foreign matter to enter the brake master cylinder reservoir.
* Make sure that fluid supply is not affected by cutting tube.
(b) Install the brake master cylinder reservoir to the master cylinder body.

(c) Fix the brake master cylinder in a vise between aluminum plates.

NOTICE:
Do not overtighten the vise.

(d) Using a pin punch and a hammer, tap in the straight pin.





3. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER

4. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY