Removal

E350 MANUAL TRANSAXLE: SHIFT AND SELECT LEVER SHAFT: REMOVAL

1. REMOVE CONTROL SHIFT LEVER BUSHING

(a) Remove the control shift lever bushing from the No. 2 selecting bellcrank.





2. REMOVE NO. 1 SELECTING BELLCRANK DUST COVER

(a) Remove the No. 1 selecting bellcrank dust cover from the No. 2 selecting bellcrank.





3. REMOVE SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY

(a) Remove the nut, wave washer and No. 2 selecting bellcrank plate washer from the No. 2 selecting bellcrank.





(b) Remove the selecting bellcrank support sub-assembly from the No. 2 selecting bellcrank.





4. REMOVE NO. 2 SELECTING BELLCRANK DUST COVER

(a) Remove the No. 2 selecting bellcrank dust cover from the No. 2 selecting bellcrank.





5. REMOVE NO. 2 SELECTING BELLCRANK BUSHING

(a) Remove the No. 2 selecting bellcrank bushing from the No. 2 selecting bellcrank.





6. REMOVE NO. 2 SHIFT LEVER INNER

(a) Hold the shift and select lever shaft in a vise using aluminum plates.





NOTICE:

Do not damage the shift and select lever shaft.

(b) Using a pin punch (dia 5 mm), remove the 2 shift inner lever slotted pins.

NOTICE:

Do not damage the shift and select lever shaft.

(c) Apply force to the No. 1 select return compression spring and No. 2 select return compression spring, then hold them in a vise using aluminum plates.

(d) Using 2 screwdrivers and a hammer, remove the select spring No. 2 seat snap ring from the shift and select lever shaft.





HINT

Use a piece of cloth to keep the snap ring from flying off.

NOTICE:

Do not damage the shift and select lever shaft.

(e) Remove the No. 2 select spring seat, No. 2 select return compression spring, and No. 2 shift lever inner from the shift and select lever shaft.





7. REMOVE NO. 1 SELECT SPRING SEAT

(a) Remove the shift interlock plate, No. 1 select return compression spring and No. 1 select spring seat from the shift and select lever shaft.





8. REMOVE SHIFT INTERLOCK PLATE COVER

(a) Remove the shift interlock plate cover from the shift interlock plate.





9. REMOVE NO. 1 SHIFT LEVER INNER

(a) Remove the No. 1 shift lever inner from the shift interlock plate.





10. REMOVE SELECT SPRING NO. 1 SEAT SHAFT SNAP RING

(a) Using 2 screwdrivers and a hammer, remove the select spring No. 1 seat shaft snap ring.





HINT

Use a piece of cloth to keep the snap ring from flying off.

NOTICE:

Do not damage the shift and select lever shaft.

11. REMOVE SHIFT AND SELECT LEVER SHAFT DUST BOOT

(a) Remove the shift and select lever shaft dust boot from the control shaft cover.





12. REMOVE CONTROL SHAFT COVER OIL SEAL

(a) Using a screwdriver, remove the control shaft cover oil seal from the control shaft cover.





HINT

Tape the screwdriver tip before use to avoid damage.