Installation

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT SEAT SIDE AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY

CAUTION:
* The nuts must not be reused.
* Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.
(a) Install the front seat side airbag assembly with the 2 new nuts.





Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(b) Engage the 2 clamps to connect the wire harness.

(c) Engage the 4 clamps to connect the wire harness.





2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

(a) Install the separate type front seatback cover with pad Reassembly.

3. INSTALL RECLINING REMOTE CONTROL BEZEL Reassembly

4. INSTALL FRONT SEAT ASSEMBLY Installation

5. INSPECT AND ADJUST SEAT SLIDE ADJUSTER LOCKS Installation

6. INSTALL SEAT TRACK BRACKET COVER OUTER LH Installation

7. INSTALL SEAT TRACK BRACKET COVER INNER LH Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

9. PERFORM INITIALIZATION Installation

10. INSPECT SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.