Installation

LIGHTING: REAR COMBINATION LIGHT ASSEMBLY: INSTALLATION

HINT

* Use the same procedures for the RH side and LH side.

* The procedures listed below are for the LH side.

1. INSTALL REAR COMBINATION LIGHT ASSEMBLY

(a) Engage the guide and pin.





(b) Install the rear combination light assembly with 3 the nuts.

Torque : 4.9 Nm (50 kgf-cm, 43 in-lbf)

(c) Connect the connector and engage the clamp.





2. INSTALL REAR COMBINATION LIGHT SERVICE COVER

(a) Engage the 2 guides.





(b) Engage the claw and install the rear combination light service cover.

3. INSTALL REAR BUMPER COVER Installation