Reassembly

LIGHTING: REAR COMBINATION LIGHT ASSEMBLY: REASSEMBLY

HINT

* Use the same procedures for the RH side and LH side.

* The procedures listed below are for the LH side.

1. INSTALL REAR BUMPER SIDE BRACKET

(a) Engage the 4 claws and install the rear bumper side bracket.





2. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY

(a) Engage the 2 clamps and install the rear combination light socket and wire sub-assembly.





3. INSTALL REAR TURN SIGNAL LIGHT BULB

(a) Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.

(b) Turn the rear turn signal light bulb and rear combination light socket and wire sub-assembly in the direction indicated by the arrow and install them as a unit.





4. INSTALL TAIL AND STOP LIGHT BULB

(a) Install the tail and stop light bulb to the rear combination light socket and wire sub-assembly.

(b) Turn the tail and stop light bulb and rear combination light socket and wire sub-assembly in the direction indicated by the arrow and install them as a unit.





5. INSTALL BACK-UP LIGHT BULB

(a) Install the back-up light bulb to the rear combination light socket and wire sub-assembly.

(b) Turn the back-up light bulb and rear combination light socket and wire sub-assembly in the direction indicated by the arrow and install them as a unit.





6. INSTALL REAR COMBINATION LIGHT BODY GASKET

(a) Install a new rear combination light body gasket.