Installation

AIR CONDITIONING: COMPRESSOR: INSTALLATION

1. INSTALL COOLER COMPRESSOR ASSEMBLY

(a) Install the cooler compressor with the 4 bolts.

Torque : 25 Nm (255 kgf-cm, 18 ft-lbf)

NOTICE:

Tighten the bolts in the order shown in the illustration to install the cooler compressor.

(b) Connect the connector.

2. INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

(a) Remove the attached vinyl tape from the hose.

(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.

Compressor oil:

ND-OIL 8 or equivalent

(c) Install the O-ring on the cooler refrigerant suction hose.

(d) Install the cooler refrigerant suction hose on the cooler compressor with the bolt.

Torque : 9.8 Nm (100 kgf-cm, 7 ft-lbf)

4. INSTALL FAN & GENERATOR V BELT Installation

5. INSTALL ENGINE UNDER COVER RH

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. PERFORM INITIALIZATION

(a) Perform initialization Testing and Inspection.

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

8. CHARGE REFRIGERANT Service and Repair

9. WARM UP ENGINE Service and Repair

10. INSPECT FOR REFRIGERANT LEAK Service and Repair