Reassembly

MIRROR: OUTER REAR VIEW MIRROR: REASSEMBLY

1. INSTALL SIDE TURN SIGNAL LIGHT LENS LH





(a) First set the lens position by inserting the lens peg to the location labeled A in the illustration. Then insert the lens guide to the V-shaped groove as shown in C in the illustration.

(b) Install the lens with the 2 screws labeled B.

(c) Connect the connector.

2. INSTALL MIRROR GARNISH

3. CONNECT MIRROR





HINT

Before connecting the mirror holder, use a dryer to sufficiently heat the backside of the mirror holder where the claws are located.

NOTICE:

If the ambient temperature is low and the claws are not heated before installing, the claws may be broken.