Reassembly

C50 MANUAL TRANSAXLE: SHIFT AND SELECT LEVER SHAFT: REASSEMBLY

REASSEMBLY

1. INSTALL SELECT SPRING NO.1 SEAT SHAFT SNAP RING





(a) Coat the shift and select lever shaft with MP grease, and install a snap ring onto the shift and select lever shaft using a brass bar and a hammer.





2. INSTALL SELECT INNER LEVER
(a) Coat the No. 1 select spring seat with MP grease.
(b) Using a pin punch (dia5 mm) and a hammer, install the No. 1 select spring seat, No. 1 select return compression spring, select inner lever and select inner lever slotted spring pin onto the shift and select lever.
Drive in depth:
3.0 to 4.0 mm (0.1181 to 0.1575 in)





3. INSTALL NO. 1 SHIFT LEVER INNER
(a) Coat the shift inter lock plate and No. 1 shift lever inner with MP grease.
(b) Using a pin punch (dia5 mm) and a hammer, install the shift inter lock plate, No. 1 shift lever inner and shift inner lever slotted spring pin onto the shift and select lever shaft.
Drive in depth:
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)





4. INSTALL NO. 2 SHIFT LEVER INNER
(a) Coat the No. 2 shift lever inner with MP grease.
(b) Using a pin punch (dia5 mm) and a hammer, install the No. 2 shift lever inner and shift inner lever slotted spring pin onto the shift and select lever shaft.
Drive in depth:
1.0 to 2.0 mm (0.0394 to 0.0787 in.)





5. INSTALL NO. 2 SELECT SPRING SEAT
(a) Coat the No. 2 select spring seat with MP grease.
(b) Install the No. 2 select spring seat and No. 2 select return compression spring. Using pliers, install a new select spring seat No. 2 E-ring onto the shift and select lever shaft.