Installation

CLUTCH: CLUTCH RELEASE CYLINDER: INSTALLATION

INSTALLATION





1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY
(a) Install the clutch release cylinder with the 2 bolts.
Torque: 12 Nm (120 kgf-cm, 9 ft-lbf)





2. CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE
(a) Using a union nut wrench, connect the flexible hose tube.
without union nut wrench - Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
with union nut wrench - Torque: 14 Nm (144 kgf-cm, 10 ft-lbf)
NOTICE:
- This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and a union nut wrench with a fulcrum length of 22 mm (0.866 in.) Service Precautions.
- This torque value is effective when union nut wrench is parallel to a torque wrench.

3. BLEED CLUTCH PIPE LINE
(a) Fill the brake reservoir tank with brake fluid and bleed the clutch system.
Torque: 8.3 Nm (85 kgf-cm, 73 in-lbf)
4. INSPECT FOR CLUTCH FLUID LEAK