Installation

U341E AUTOMATIC TRANSAXLE: TRANSMISSION WIRE: INSTALLATION

INSTALLATION

1. INSTALL TRANSMISSION WIRE





(a) Coat a new O-ring with Toyota Genuine ATF WS or equivalent and install it onto the transmission wire.





(b) Pass the transmission wire through the transaxle.





(c) Install the transmission wire with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY Installation
3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY Installation
4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY Installation
5. ADD AUTOMATIC TRANSAXLE FLUID
6. INSPECT AUTOMATIC TRANSAXLE FLUID LEVEL Procedures
7. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK
8. INSTALL ENGINE UNDER COVER LH
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)