Installation

SUSPENSION: FRONT SHOCK ABSORBER WITH COIL SPRING: INSTALLATION

INSTALLATION

1. TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING





(a) Provisionally tighten a new nut through No. 2 suspension support.
(b) Install the front shock absorber with coil spring onto the steering knuckle.





(c) Install the 2 bolts and 2 nuts.
Torque: 164 Nm (1672 kgf-cm, 121 ft-lbf)
HINT: Keep the bolt from rotating while loosening and removing the nuts.





2. INSTALL FRONT FLEXIBLE HOSE
(a) Install the flexible hose and speed sensor with the bolt.
Torque: 29 Nm (300 kgf-cm, 22 ft-lbf)
NOTICE: Install the flexible hose and speed sensor without twisting them.





3. INSTALL FRONT STABILIZER LINK ASSEMBLY
(a) Install the stabilizer link with the nut.
Torque: 74 Nm (755 kgf-cm, 55 ft-lbf)
HINT: If the ball joint turns together with the nut, use a socket hexagon wrench 6 to hold the stud.

4. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)





5. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
(a) Using a socket hexagon wrench 6, fix the shock absorber rod and tighten the nut.
Torque: 55 Nm (561 kgf-cm, 41 ft-lbf)
6. INSTALL FRONT SUSPENSION SUPPORT DUST COVER
7. INSTALL OUTER COWL TOP PANEL Installation
8. INSTALL FRONT AIR SHUTTER SEAL RH Installation
9. INSTALL FRONT WIPER MOTOR AND LINK Installation
10. INSTALL COWL TOP VENTILATOR LOUVER LH Installation
11. INSTALL COWL TOP VENTILATOR LOUVER RH Installation
12. INSTALL HOOD TO COWL TOP SEAL Installation
13. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation
14. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation
15. INSTALL FRONT WIPER ARM HEAD CAP Installation
16. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Front Wheel Alignment