DTC Check / Clear

U341E AUTOMATIC TRANSAXLE: AUTOMATIC TRANSAXLE SYSTEM: DTC CHECK / CLEAR

DTC CHECK / CLEAR

1. CHECK DTC
(a) DTCs which are stored in the ECM can be displayed with a Techstream.
These scan tools can display pending DTCs and current DTCs. Some DTC are not stored if the ECM does not detect a malfunction during consecutive driving. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the tester ON.
(4) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(5) Check the DTCs and freeze frame data and then write them down.
(6) Check the details of the DTCs Automatic Transaxle System - U341E.
2. CLEAR DTC (using a Techstream)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the tester ON.
(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(e) Erase the DTCs.
3. CLEAR DTC (without using a Techstream)
(a) Perform either of the following operations.
(1) Disconnect the negative battery cable for more than 1 minute.
(2) Remove the EFI and ETCS fuse from the engine room relay block located inside the engine compartment for more than 1 minute.