Engine - Oil Filter Cap Assembly Precaution

S-SB-0024-09

April 10, 2009

Oil Filter Cap Assembly Precautions

Service Category
Engine/Hybrid System

Section
Lubrication

Market
USA





Applicability

TSB SUPERSESSION NOTICE

The information contained in this TSB supersedes TSB No. S-SB-0049-08.

^ The SST table has been updated with an illustration.

^ The Notice in the Repair Procedure has been updated with a Figure and torque specification ranges to clarify SST usage.

TSB No. S-SB-0049-08 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before proceeding.

Introduction

Applicable vehicles are equipped with a plastic oil filter cap assembly. To prevent damage to the oil filter cap assembly this procedure must be closely followed during oil filter replacement to avoid immediate and future oil filter serviceability concerns.





Warranty Information

NOTE
Additional SSTs may be ordered by calling 1-800-933-8335.





Repair Procedure

Refer to the Technical Information System (TIS) when replacing the oil filter:

2008 / 2009 Scion xD Repair Manual Engine/Hybrid System - Lubrication - "2ZR-FE Lubrication: Oil and Oil Filter: Replacement"