Installation

BRAKE CONTROL: FRONT SPEED SENSOR: INSTALLATION

INSTALLATION

1. INSTALL FRONT SPEED SENSOR





(a) Install the speed sensor onto the steering knuckle with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTICE:
- Check that the speed sensor tip and installation portion are free of foreign matter.
- Install the speed sensor without turning it from its original installation angle.

(b) Install the No. 1 sensor clamp onto the shock absorber with the bolt.
Torque: 29 Nm (300 kgf-cm, 22 ft-lbf)
(c) Install the No. 2 sensor clamp onto the body with the bolt.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
(d) Engage the clamps D, C and B onto the body.
(e) Connect the speed sensor connector.
(f) Engage the clamp A onto the body.
2. INSTALL FRONT FENDER LINER Installation
3. INSTALL SIDE MUDGUARD Installation
4. INSTALL ROCKER PANEL MOULDING COVER Installation
5. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
6. CHECK ABS SENSOR SIGNAL (w/o VSC)
Test Mode Procedure
7. CHECK VSC SENSOR SIGNAL (w/ VSC)
Test Mode Procedure