Installation

U241E AUTOMATIC TRANSAXLE: TRANSMISSION WIRE: INSTALLATION

INSTALLATION

1. INSTALL TRANSMISSION WIRE





(a) Coat a new O-ring with ATF and install it into the transmission wire.
(b) Pass the transmission wire through the transaxle case.





(c) Install the transmission wire with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)





(d) Coat the O-ring on the ATF temperature sensor with ATF.
(e) Install the ATF temperature sensor with the lock plate and bolt.
Torque: 6.6 Nm (67 kgf-cm, 58 in-lbf)
(f) Connect the 5 shift solenoid valve connectors.
2. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY





(a) Install the 2 oil cleaner magnets onto the automatic transaxle oil pan sub-assembly, as shown in the illustration.





(b) Install the automatic transaxle oil pan sub-assembly and a new oil pan gasket with the 18 bolts.
Torque: 7.8 Nm (80 kgf-cm, 69 in-lbf)
3. ADD AUTOMATIC TRANSAXLE FLUID
Fluid type:
Toyota Genuine ATF WS
4. INSPECT AUTOMATIC TRANSAXLE FLUID Procedures
5. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK
6. INSTALL NO. 1 ENGINE UNDER COVER