Removal

AXLE: STEERING KNUCKLE: REMOVAL

REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. REMOVE FRONT WHEEL
2. REMOVE FRONT AXLE HUB NUT Removal
3. SEPARATE FRONT SPEED SENSOR Removal
4. SEPARATE TIE ROD END SUB-ASSEMBLY Removal
5. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Removal
6. REMOVE FRONT DISC Removal
7. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY Removal
8. REMOVE FRONT AXLE ASSEMBLY Removal
9. REMOVE FRONT LOWER BALL JOINT ASSEMBLY Removal
10. REMOVE STEERING KNUCKLE





(a) Remove the 4 bolts and axle hub from the steering knuckle.
NOTICE: Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.

(b) Remove the front disc brake dust cover from the steering knuckle.