Installation

2AZ-FE LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION

INSTALLATION

1. INSTALL OIL PRESSURE SWITCH





(a) Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
(b) Using a deep socket wrench 24 mm, install the oil pressure switch.
Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)
NOTICE: Do not start the engine within 1 hour of installation.

(c) Connect the connector.
2. CHECK ENGINE OIL LEVEL
Testing and Inspection
3. INSPECT FOR ENGINE OIL LEAK