Installation

2AZ-FE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR





(a) Install a new gasket onto the sensor.
(b) Using SST, install the sensor.
SST: 09817-33190
Torque: 20 Nm (204 kgf-cm, 14 ft-lbf)
(c) Connect the sensor connector.
2. INSTALL AIR CLEANER ASSEMBLY





(a) Install the air cleaner case sub-assembly with the 3 bolts.
Torque: 7.0 Nm (71 kgf-cm, 62 in-lbf)
(b) Install the wire harness to the air cleaner case sub-assembly.
(c) Install the air cleaner filter element sub-assembly.





(d) Install and lock the air cleaner cap sub-assembly and air cleaner hose and then tighten the No. 1 air cleaner hose clamp.





(e) Connect the No. 2 fuel vapor feed hose.
(f) Connect the No. 2 ventilation hose to the air cleaner hose.





(g) Install the vacuum switching valve assembly.





(h) Install the wire harness.
(i) Connect the mass air flow meter connector.
3. ADD ENGINE COOLANT Service and Repair
4. INSPECT FOR COOLANT LEAK Testing and Inspection