Installation

BRAKE CONTROL: REAR SPEED SENSOR: INSTALLATION

INSTALLATION

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY Installation
2. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub
3. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub





4. CONNECT SPEED SENSOR WIRE
(a) Connect the speed sensor wire connector to the speed sensor.
5. INSTALL REAR DISC Installation
6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Installation
7. INSTALL PARKING BRAKE CABLE ASSEMBLY Installation
8. INSTALL REAR FLOOR SIDE MEMBER COVER Installation
9. ADJUST PARKING BRAKE LEVER TRAVEL Adjustments
10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation
11. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
13. INSPECT REAR WHEEL ALIGNMENT
Rear Wheel Alignment
14. CHECK VSC SENSOR SIGNAL
Test Mode Procedure