Reassembly

CLUTCH: CLUTCH MASTER CYLINDER: REASSEMBLY

CLUTCH: CLUTCH MASTER CYLINDER: REASSEMBLY

1. INSTALL CLUTCH MASTER CYLINDER KIT





(a) Coat the parts indicated by arrows with lithium soap base glycol grease.
(b) Install the piston with the spring into the cylinder.
NOTICE: Be careful not to damage the inside of the cylinder body.

(c) Install the stop plate to the push rod.
(d) Install the push rod to the cylinder body.





(e) Using snap ring pliers, install the snap ring while pushing on the piston rod.
(f) Install the boot to the cylinder body.
(g) Install the lock nut to the push rod.
(h) Temporarily install the clevis with the lock nut to the push rod.
(i) Install the inlet union and a new grommet.





(j) Using a pin punch and hammer, tap in the slotted spring pin.
Standard protrusion:
1.5 to 3.5 mm (0.059 to 0.138 in.)