Fuel System

2AZ-FE FUEL: FUEL SYSTEM: ON-VEHICLE INSPECTION

2AZ-FE FUEL: FUEL SYSTEM: ON-VEHICLE INSPECTION

1. CHECK FUEL PUMP OPERATION
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON and turn the Techstream on.
NOTICE: Do not start the engine.

(c) Enter the following menus: Powertrain / Engine / Active Test / Control the Fuel Pump / Speed.
(d) Check for pressure in the fuel inlet tube from the fuel line. Check that sounds of fuel flowing from the fuel tank can be heard.
(e) Stop the fuel pump.
If there is no fuel flow, the fuel pump may not operate. Check the fuel pump circuit Fuel Pump Control Circuit.
2. CHECK FUEL PRESSURE
(a) Check that the battery positive voltage is above 12 V.
(b) Disconnect the cable from the negative (-) battery terminal.

(d) Disconnect the fuel tube connector from the fuel pipe by pinching part A with your fingers, as shown in the illustration.
CAUTION:
- Always read the precautions Fuel System Precautions before disconnecting the fuel tube connector (quick type).
- The fuel pipe line may spray fuel as a result of retained pressure that remains in it. Do not allow fuel to be sprayed in the engine compartment.

(e) Install SST (pressure gauge) and the fuel tube connector using SST as shown in the illustration.
SST: 09268-31012
09268-41500
90467-13001
95336-08070
SST: 09268-45014
09268-41200
09268-41220
09268-41250
(f) Wipe up any gasoline.
(g) Connect the cable to the negative (-) battery terminal.
(h) When using the Techstream:
Operate the fuel pump (See step 1).
(i) Measure the fuel pressure.
Fuel pressure:
304 to 343 kPa (3.1 to 3.5 kgf/cm2, 44 to 50 psi)
If the pressure is high, replace the fuel pressure regulator.
If the pressure is low, check the fuel hoses and connections, fuel pump, fuel filter and fuel pressure regulator.
(j) Start the engine.
(k) Measure the fuel pressure at idle.
Fuel pressure:
304 to 343 kPa (3.1 to 3.5 kgf/cm2, 44 to 50 psi)
(l) Stop the engine.
(m) Check that the fuel pressure remains as specified for 5 minutes after the engine has stopped.
Fuel pressure:
147 kPa (1.5 kgf/cm2, 21 psi)
If the pressure is not as specified, check the fuel pump, pressure regulator and/or injectors.
(n) After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST and the fuel tube connector to prevent gasoline from spraying.
(o) Reconnect the fuel inlet tube (fuel tube connector).
CAUTION: Always read the precautions Fuel System Precautions before connecting the fuel tube connector (quick type).