DTC Check / Clear

2AZ-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: DTC CHECK / CLEAR

DTC CHECK / CLEAR
NOTICE: When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are erased. Before changing modes, always check and make a note of DTCs and freeze frame data.
HINT:
- DTCs which are stored in the ECM can be displayed on the Techstream. The Techstream can display current and pending DTCs.
- Some DTCs are not set if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.

1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to the ON position.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(e) Check the DTC(s) and freeze frame data, and then write them down.
(f) Check the details of the DTC(s) Engine Control System - SFI System.
2. CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to the ON position.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(e) Clear the DTCs.
3. CLEAR DTC (Without using the Techstream)
(a) Perform either one of the following operations:
(1) Disconnect the negative (-) battery cable for more than 1 minute.
(2) Remove the EFI and ETCS fuses from the relay block located inside the engine compartment for more than 1 minute.
NOTICE: When disconnecting the battery cable, perform the INITIALIZE procedure Testing and Inspection.