Installation

TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER: INSTALLATION

TIRE PRESSURE WARNING RECEIVER: INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY





(a) Install the tire pressure warning receiver assembly with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(b) Connect the connector.
2. INSTALL NO. 1 SIDE TRIM ASSEMBLY RH Installation
3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
4. INSTALL REAR SEATBACK ASSEMBLY RH Installation
5. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
6. INSTALL FRONT DOOR SCUFF PLATE RH Installation
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
HINT: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Testing and Inspection.

8. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT: Test Mode Procedure.