Disassembly

LIGHTING: REAR COMBINATION LIGHT ASSEMBLY: DISASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY: DISASSEMBLY
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. REMOVE REAR COMBINATION LIGHT BODY GASKET





(a) Remove the rear combination light body gasket.
NOTICE:
- Be sure to remove all traces of the old gasket from the body.
- Do not reuse the removed gasket. Be sure to install a new rear combination light body gasket to prevent water ingress.

2. REMOVE BACK-UP LIGHT BULB





(a) Turn the back-up light bulb and the rear combination light socket and wire sub-assembly in the direction indicated by the arrow and disconnect them as a unit.
(b) Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.
3. REMOVE TAIL AND STOP LIGHT BULB





(a) Turn the tail and stop light bulb and the rear combination light socket and wire sub-assembly in the direction indicated by the arrow and disconnect them as a unit.
(b) Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly.
4. REMOVE REAR TURN SIGNAL LIGHT BULB





(a) Turn the rear turn signal light bulb and the rear combination light socket and wire sub-assembly in the direction indicated by the arrow and disconnect them as a unit.
(b) Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.
5. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY





(a) Disengage the 2 clamps and remove the rear combination light socket and wire sub-assembly.
6. REMOVE REAR BUMPER SIDE BRACKET





(a) Disengage the 4 claws and remove the rear bumper side bracket.