Hazard Warning Switch: Testing and Inspection

LIGHTING: HAZARD WARNING SWITCH: INSPECTION

INSPECTION

1. INSPECT HAZARD WARNING SWITCH





(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard resistance:






If the result is not as specified, replace the hazard warning switch.
(b) Check the illumination operation.
(1) Connect the positive (+) battery lead to terminal 5 (Ill+) and the negative (-) battery lead to terminal 6 (Ill-), then check that the illumination illuminates.
OK:
Illumination illuminates.
If the illumination does not illuminate, replace the hazard warning switch.