Installation

SEAT BELT: REAR SEAT INNER BELT ASSEMBLY (for LH Side): INSTALLATION

INSTALLATION
NOTE: Always use "TORX" socket wrench E10 when installing the rear seat.

1. INSTALL REAR SEAT INNER BELT ASSEMBLY






(a) Install the rear seat inner belt with the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
NOTE: Do not place the anchor plate over the convex area of the rear seat back frame.

(b) Install the belt into the band.






(c) Install the rear seat cushion.
(d) Using "TORX" socket wrench E10, tighten the 3 bolts in the sequence shown in the illustration.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)
2. INSTALL NO. 2 REAR SEAT LEG COVER Installation

3. INSTALL NO. 1 REAR SEAT LEG COVER Installation