Ignition Switch: Service and Repair

Ignition Switch:

IGNITION SWITCH

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE STEERING COLUMN COVER




a. Remove the 2 screws and cover lower.

HINT: Turn the steering wheel to the right and left as necessary to remove the 2 screws and cover lower.

3. REMOVE IGNITION SWITCH ASSEMBLY




a. Disconnect the ignition switch connector.
b. Disconnect the unlock warning switch connector.




c. Remove the cable tie.
d. Using a small screwdriver, disconnect the claw fitting, and then remove the connector of the unlock warning switch.




e. Remove the 2 screws and ignition switch.




f. Remove the screw and lock stopper.

INSTALLATION

1. INSTALL IGNITION SWITCH ASSEMBLY




a. Install the lock stopper with the screw.




b. Install the ignition switch with the 2 screws.




c. Align the claw position, and then install the connector of the unlock warning switch.
d. Install the cable tie.




e. Connect the unlock warning switch connector.
f. Connect the ignition switch connector.

2. INSTALL STEERING COLUMN COVER




a. Install the cover lower with the 2 screws.

HINT: Turn the steering wheel to the right and left as necessary to install the 2 screws and cover lower.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.