Rear Airbag Sensor

Rear Airbag Sensor:

REAR AIRBAG SENSOR

REMOVAL

CAUTION: Refer to Restraint Systems; Service Precautions before servicing the SRS system or related components.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE TONNEAU COVER ASSEMBLY
3. REMOVE FRONT DOOR SCUFF PLATE LH
4. REMOVE FRONT DOOR WEATHERSTRIP LH
5. REMOVE DECK TRIM SIDE PANEL ASSEMBLY
6. REMOVE AIRBAG SENSOR REAR LH




a. Disconnect the connector.
b. Remove the 2 nuts and airbag sensor.

INSTALLATION

CAUTION: Refer to Restraint Systems; Service Precautions before servicing the SRS system or related components.

1. INSTALL AIRBAG SENSOR REAR LH
a. Install the airbag sensor with the 2 nuts.

Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)

NOTE:
- If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
3. INSTALL FRONT DOOR WEATHERSTRIP LH
4. INSTALL FRONT DOOR SCUFF PLATE LH
5. INSTALL TONNEAU COVER ASSEMBLY
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

8. CHECK SRS WARNING LIGHT
a. Check the SRS warning light.