Programming and Relearning

CUSTOMIZE PARAMETERS

SEAT BELT BUZZER ON/OFF SETTING

The buzzer ON/OFF setting, which is a setting of the buzzer function of the combination meter, can disable the driver and front passenger side seat belt buzzers.

NOTE:
- These buzzers should be on for safe driving. Perform these procedures only if it is necessary to set the buzzer off (disabled).
- When either the battery cable or the combination meter connector is disconnected, these buzzers are set on (enabled).
- Odometer returns to 0 after starting this procedure, although it is not displayed.

HINT:
- "b-oFF" indicates that the buzzer is OFF. "b-on" indicates that the buzzer is ON. The buzzer ON/OFF setting will be finished (the odometer will display "ODO") if the ODO/TRIP switch is not operated for 10 seconds or more. In this case, perform step 11 to check that the buzzer ON/OFF setting is complete. If it is not complete, start from step 1 again.
- The legally required warning buzzer cannot be cancelled.
- The legally required warning buzzer is the buzzer that sounds when turn the ignition switch to the ON position and the driver seat belt is unfastened.

The buzzer sounds in order to warn the driver regardless of the vehicle speed.

a. Turn the ignition switch to the ON position.
b. Press the ODO/TRIP switch until the odometer displays "ODO".
c. Turn the ignition switch off.
d. Turn the ignition switch to the ON position.
e. Press the ODO/TRIP switch immediately (within 6 seconds) and hold it down for 10 seconds or more.
f. Continue holding down the ODO/TRIP switch and fasten the driver side seat belt.
g. Check that the odometer displays either "b-on" or "b-oFF".
h. Press the ODO/TRIP switch to change the display to "b-oFF".
i. Turn the ignition switch off.
j. Engine switch off.
k. Check that no buzzer sounds with the vehicle speed is 15 km/h or more and driver side seat belt is unfastened.