Initial Inspection and Diagnostic Overview

CHECK SEAT BELT WARNING LIGHT FOR DRIVER SIDE




a. Disconnect the B7 switch connector.
b. Connect terminals 1 and 3 of the wire harness side connector.
c. Turn the ignition switch ON, and then check that the warning light turns on.

OK:
Seat belt warning light for driver side turns on.

If the result is not as specified, the combination meter may have a malfunction.

CHECK SEAT BELT WARNING LIGHT FOR PASSENGER SIDE




a. Disconnect the B8 switch connector.
b. Connect terminals 1 and 3 of the wire harness side connector.
c. Turn the ignition switch ON, and then check that the warning light blinks.

OK:
Seat belt warning light for passenger side blinks.

If the result is not as specified, the integration control and panel may have a malfunction.