Instrument Panel Bulb: Testing and Inspection
CHECK ILLUMINATIONa. Check the door unlock illuminated system.
HINT: "All doors" is a phrase used to refer to: the driver side door, front passenger side door, rear left door, rear right door and back door.
1. Set the room light switch to the DOOR position.
2. Close all doors and lock them (using the door control switch, wireless operation or key operation).
3. When the wireless operation or key operation is used to unlock the doors, check that the room light illuminates and then fades out after 15 seconds.
HINT: Starting the next step (illuminated entry system) while the room light is still illuminated will stop the door unlock illuminated system and begin the illuminated entry system.
b. Check the illuminated entry system.
HINT: "All doors" is a phrase used to refer to: the driver side door, front passenger side door, rear left door, rear right door and back door. "One of the doors" is a phrase used to refer to any one of the doors mentioned above.
1. Set the room light switch to the DOOR position.
2. With all doors closed, open one of the doors and the room light will illuminate. Check that closing the opened door causes the room light to fade out after 15 seconds.
3. With all doors closed and the room light illuminated, check that setting the doors to LOCK (using the door control switch, wireless operation or key operation) causes the room light to immediately fade out.
4. With all doors closed and the room light illuminated, check that turning the ignition switch from OFF to ON causes the room light to immediately fade out.
HINT:
- If the room light remains illuminated for 20 minutes, the room light will enter battery save mode and automatically fade out.
- The battery save mode timer is reset if: 1) the key is inserted into the ignition key cylinder, or 2) one of the doors is opened or closed.