Audible Warning Device: Testing and Inspection

CHECK KEY REMINDER WARNING BUZZER




a. Disconnect the U1 switch connector.
b. Connect terminals 1 and 2 of the wire harness side connector.
c. Disconnect the D5 switch connector.
d. Connect terminals 1 and the body ground of the wire harness side connector.
e. Turn the ignition switch ON, and check that the warning buzzer sounds.

OK:
Warning buzzer sounds.

CHECK LIGHT REMINDER WARNING BUZZER




a. Disconnect the D5 switch connector.
b. Connect terminal 1 and the body ground of the wire harness side connector.
c. Turn the light control switch to HEAD or TAIL, and then check that the warning buzzer sounds when the ignition key is not inserted into the key cylinder.

OK:
Warning buzzer sounds.