Throttle Position Sensor: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE THROTTLE BODY ASSEMBLY
a. Remove the throttle body.
3. REMOVE THROTTLE POSITION SENSOR
a. Remove the 2 screws and sensor.
INSTALLATION
1. INSTALL THROTTLE POSITION SENSOR
a. Install the sensor with the 2 screws.
Torque: 2.0 N.m (20 kgf.cm, 18 in.lbf)
2. INSTALL THROTTLE BODY ASSEMBLY
a. Install the throttle body.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.