Center Cluster Box Illumination

CENTER CLUSTER BOX ILLUMINATION

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER

5. REMOVE CENTER CLUSTER BOX ILLUMINATION
a. Disconnect the connector.
b. Remove the light.

INSTALLATION

1. INSTALL CENTER CLUSTER BOX ILLUMINATION
a. Install the light.
b. Connect the connector.

2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER
3. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
4. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.