Crankshaft: Specifications

Crankshaft
Maximum circle runout 0.03 mm (0.0012 inch)
Main journal
Standard diameter 45.988 to 46.000 mm (1.8106 to 1.8110 inch)
Maximum taper & distortion 0.02 mm (0.0008 inch)
Crank pin
Standard diameter 39.992 to 40.000 mm (1.5745 to 1.5748 inch)
Maximum taper & distortion 0.02 mm (0.0008 inch)

Crankshaft Main Bearing Size Codes

Reference:

Standard cylinder block diameter:

Standard crankshaft journal diameter:

Crankshaft Sprocket





Sprocket diameter (w/chain)
Standard 51.72 mm (2.0362 inch)
Minimum 50.5 mm (1.988 inch)

Crankshaft Main Bearing Cap Bolts





Diameter
Standard 7.3 to 7.5 mm (0.287 to 0.295 inch)
Minimum 7.2 mm (0.283 inch)





First pass 22 Nm (224 kgf-cm, 16 ft. lbs.) in several steps
Final pass Tighten 90°