Skid Control Sensor

SKID CONTROL SENSOR
REPLACEMENT

HINT: Replace the RH side by using the same procedures as those for the LH side.

1. REMOVE REAR WHEEL





2. DISCONNECT SKID CONTROL SENSOR WIRE
a. Disconnect the connector from the skid control sensor.
3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
a. Put matchmarks on the rear brake drum sub-assembly and the axle hub.
b. Remove the rear brake drum sub-assembly.
4. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH





5. REMOVE SKID CONTROL SENSOR
a. Mount the hub & bearing assembly in a soft jaw vise.

NOTICE: Replace the hub & bearing assembly if it is dropped or receives a strong shock.

b. Using a pin punch and hammer, drive out the 2 pins, and remove the 2 attachments from SST.
c. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub.
SST 09520-00031 (09520-00040), 09521-00020, 09950-00020

NOTICE:
^ If the sensor rotor is damaged, replace the hub & bearing assembly.
^ Do not scratch the contacting surface of the hub & bearing assembly and the skid control sensor.

6. INSTALL SKID CONTROL SENSOR





a. Clean the contacting surface of the rear axle hub and a assembly and a new skid control sensor.

NOTICE: Make sure the sensor rotor is clean.

b. Place the skid control sensor in the rear axle hub so that the connector makes the lowest position under the on vehicle condition.





c. Using SST and a press, install the skid control sensor onto the hub & bearing assembly.
SST 09214-76011

NOTICE:
^ Do not tap the skid control sensor directly with a hammer.
^ Check that the skid control sensor detection part is clean.
^ Press in the skid control sensor straight and slowly.

7. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
8. INSPECT REAR AXLE DEVIATION AND BACKLASH
9. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
a. Aligning the matchmarks, install the rear brake drum sub-assembly.





10. CONNECT SKID CONTROL SENSOR WIRE
a. Connect the connector to the skid control sensor.
11. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
12. CHECK ABS SPEED SENSOR SIGNAL