Replacement

Air Bag Sensor Front LH:

REPLACEMENT

1. OBSERVE RESTRAINT SYSTEMS SERVICE PRECAUTIONS
2. SEPARATE BATTERY NEGATIVE TERMINAL




3. REMOVE AIR CLEANER INLET NO.1
a. Remove the bolt and air cleaner inlet No.1.




4. REMOVE AIR BAG SENSOR FRONT LH
a. Remove the 2 bolts and airbag sensor front LH.
b. Disconnect the connector from the airbag sensor front LH.

5. INSTALL AIR BAG SENSOR FRONT LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.

NOTE: After removing the terminal wait for at least 90 seconds before starting the operation.

c. Install the airbag sensor front LH with the 2 bolts.

Torque: 17.5 Nm (178 kgf.cm, 13 ft.lbf)

NOTE:
- If the airbag sensor front LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace the airbag sensor front LH with a new one.
- When installing the airbag sensor front LH, be careful that the SRS wiring does not interfere with other parts and is not pinched between other parts.

d. Connect the connector to the airbag sensor front LH.
e. Check that there is no looseness in the installation parts of the airbag sensor front LH.

6. INSTALL AIR CLEANER INLET NO.1
a. Install the air cleaner inlet No.1 with the bolt.

Torque: 7.5 Nm (76 kgf.cm, 66 in.lbf)

7. INSPECT SRS WARNING LIGHT
Refer to Air Bag Systems; Testing and Inspection.