Engine Oil Replacement Reminder Light Reset Procedures

The accumulated mileage memorized in the meter CPU can be reset by the following procedures.

1) Turn the ignition on and make sure that the ODO/TRIP display screen is in the ODO mode. (reset procedure will not work in the TRIP mode)

2) Turn the ignition off. While pressing the ODO/TRIP switch button, turn the ignition on.
(Note: hold the button down throughout the entire reset procedure)

3) Observe the oil replacement reminder light. The light should go on solid for 3 seconds, then blink for 2 seconds, then go on solid for 1 second, and then go off.

4) When the light goes off, release the ODO/TRIP switch button. The mode should change to Trip A.

5) Turn the ignition off. Turn the ignition on again and conrirm that the oil replacement reminder light goes on for 3 seconds and then goes off.

6) This completes the reset procedure.