Replacement

Air Bag Sensor Rear LH:

REPLACEMENT

HINT: Replacement procedure of the RH side is the same as that for the LH side.

1. OBSERVE RESTRAINT SYSTEMS SERVICE PRECAUTIONS
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE DECK BOARD NO.1
4. REMOVE DECK TRIM COVER REAR
5. REMOVE REAR DOOR SCUFF PLATE LH
6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
7. REMOVE REAR SEAT CUSHION W/COVER PAD SUB-ASSEMBLY
8. REMOVE REAR SEAT BACK ASSEMBLY LH
9. REMOVE REAR SEAT BACK HINGE SUB-ASSEMBLY LH
10. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY OUTER
11. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH




12. REMOVE AIR BAG SENSOR REAR LH
a. Disconnect the connector of the airbag sensor rear LH.
b. Remove the bolt and the airbag sensor rear LH.

13. INSTALL AIR BAG SENSOR REAR LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.

NOTE: After removing the terminal wait for at least 90 seconds before starting to the operation.

c. Install the airbag sensor rear LH with the bolt.

Torque: 9.0 Nm (92 kgf.cm, 80 in.lbf)

NOTE:
- If the airbag sensor rear LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace the airbag sensor rear LH with a new one.
- When installing the airbag sensor rear LH, be careful that the SRS wiring does not interfere with other parts and is not pinched between other parts.

d. Connect the connector of the airbag sensor rear LH.
e. Check that there is no looseness in the installation parts of the airbag sensor rear LH.

14. INSTALL REAR SEAT BACK HINGE SUB-ASSEMBLY LH
15. INSTALL REAR SEAT BACK ASSEMBLY LH
16. INSPECT SRS WARNING LIGHT
Refer to Air Bag Systems; Testing and Inspection.